Farm Irrigation Controller for Pump + Valve Automation | PKYDrip
Farm irrigation controller for pump + valve automation
A practical B2B controller for farm irrigation projects and retrofit upgrades—automate pump start/stop, control valve zones, and monitor pressure/flow to improve field reliability.
Not a consumer garden timer. Built for farms, contractors, greenhouse integrators, and irrigation retrofit projects.
Common use cases
Open field irrigation
Multi-zone operation with stable pump automation for field blocks and long-run piping.
Orchard irrigation
Zoned irrigation with practical pressure verification for reliability and troubleshooting.
Irrigation retrofit projects
Upgrade manual panels to automated control with pump + valve coordination and monitoring.
Farm pump + valve automation
Reduce manual switching and add clear operational feedback for daily irrigation work.
What this controller can do
Automatic pump start / stop
Start the pump when irrigation runs, stop when zones finish, and support practical interlocks via project wiring and sensor logic.
Irrigation zone valve control
Control valves by zone with sequential operation (typical for farms) or grouped operation depending on project requirements.
Pressure and flow monitoring
Use pressure/flow inputs for alarms and operational verification (e.g. abnormal pressure, no-flow after pump start).
Practical farm irrigation automation
Designed for contractors and integrators who need a controller that fits real field panels, pumps, and valve manifolds.
Typical system structure
Pump → Controller → Valves (Zones) → Pressure / Flow Sensors
This structure helps automate irrigation execution and add measurement feedback without redesigning the hydraulic system.
Suitable projects (quick check)
- 1 pump (or a pump station where start/stop signal integration is required)
- Multiple irrigation zones (valves/manifolds)
- A need to monitor pressure and/or flow for reliability and troubleshooting
- A requirement for B2B deployment (farm operations, greenhouse integration, contractor installation)
Not for consumer garden timers
If you only need a small home garden timer or low-cost consumer controller, this product is not the right fit.
Consultation (recommended before purchase)
Most projects differ by pump type, zone quantity, sensor selection, and wiring standards. WhatsApp consultation is the fastest way to get a suitable controller configuration and avoid mismatched I/O or field wiring changes.
Send these details on WhatsApp
- Farm size / irrigation area (hectares or acres)
- Crop type (open field / orchard / greenhouse)
- Pump power (kW / HP) and pump type (AC pump, solar pump, VFD if any)
- Number of zones (valves) and valve type (solenoid / motorized)
- Water source (well, river, reservoir, tank)
- Sensors required (pressure, flow; and preferred type if known)
PKYDrip will recommend
- A matching controller configuration (pump output + zone outputs + sensor inputs)
- Practical wiring and integration notes for your panel build or retrofit
- Options for remote monitoring and integration if your project requires it
Get a suitable controller configuration
Get pump + valve + sensor configuration advice and a practical recommendation for your panel build or retrofit.
Send project details for recommendationReference code: PC-0801-2-02-PROD-FARM-CTRL-01
FAQ
Yes. It supports pump start/stop control via project wiring (typically a relay/contactor control signal). Share pump power and control panel details so we can recommend a suitable interface method.
Yes. Pressure monitoring can be integrated using appropriate sensor signal types depending on configuration (commonly analog or industrial fieldbus options).
Yes. Flow monitoring is supported for operational verification and alarms. Sensor type and wiring depend on the flowmeter specification.
Yes. It is designed for contractor installation and upgrades from manual operation to automation, especially when pump + zones + monitoring are required.
Yes. The controller manages automation and zoning. Drip/sprinkler suitability depends on your hydraulic design, valve type, and zoning plan.
Yes—send pump power, number of zones, valve type, and whether you need pressure/flow monitoring. We will recommend a practical configuration for your project.
Send your project details on WhatsApp to get a suitable controller configuration (pump + zones + sensors).
Chat on WhatsApp